Arduino LCD Display does not display message

Question

I’m using the simulator https://www.tinkercad.com.

I am unable to do it appears the test message on the display. When calling does not show message, just turn on the display.

What I’m doing wrong?

Do not pay attention to the other components, only the test message to be displayed on the LCD.

#include <LiquidCrystal.h>

int temperatura = 0;

LiquidCrystal lcd(9,8,5,4,3,2);

void setup()
{
  //Confg LCD
  lcd.begin(16,2);
  lcd.setCursor(0,0);
  lcd.print("Teste");

  //Senssor temp
  pinMode(A0, INPUT);

  //LEDs
  pinMode(11, OUTPUT);
  pinMode(12, OUTPUT);
  pinMode(13, OUTPUT);
}

void loop()
{
  temperatura = analogRead(A0);
  if (temperatura >= -40 || temperatura <= 15) {
    digitalWrite(11, HIGH);
    digitalWrite(12, LOW);
    digitalWrite(13, LOW);
  }
  if (temperatura >= 16 || temperatura <= 23) {
    digitalWrite(11, LOW);
    digitalWrite(12, HIGH);
    digitalWrite(13, LOW);
  }
  if (temperatura >= 24 || temperatura <= 125) {
    digitalWrite(11, LOW);
    digitalWrite(12, LOW);
    digitalWrite(13, HIGH);
  }


  //LCD
  lcd.setCursor(0,1);
  lcd.print("Teste 2");



  //delay(10); // Delay a little bit to improve simulation performance
}