create a bat file

Question

I need to create a file bat to change the network card’s ip and then open the cmd with a few command lines.
In this case it would be something like this:

• Change the ip
• Open the cmd
• Place necessary command lines.

Until opening the cmd I’ve done it but I can’t get it to write there afterwards, someone can help.

netsh interface ip set address name="Ethernet" static 192.168.1.1 255.255.255.0

start /max "cmd.exe"

ssh [email protected]

12345678

Answer 1

---

• If I understand the question, may I suggest that you use a bat to create a second bat and call that second one using the start /max already finishing the first bat...

---

@echo off  && >nul chcp 1252 & type nul >"%temp%\bat_to_bat.bat"
:: alterando o IP:

rem :: Configurando IP: 192.168.1.100 ^| Mascara: 255.255.255.0 ^| Gateway: 192.168.1.1
netsh interface ip set address name="Ethernet" static 192.168.1.100 255.255.255.0 192.168.1.1
rem :: Configurando DNS Primario: 1.1.1.1
netsh interface ip add dns "Ethernet" 1.1.1.1
rem :: DNS Secundario: 1.0.0.1
netsh interface ip add dns "Ethernet" 1.0.0.1 index=2

>"%temp%\bat_to_bat.bat"^
   (
    echo/    @echo off & color 0a
    echo/    ssh [usuário]@192.168.1.1
    echo/    [Senha]
   ) && start /max cmd.exe /k call "%temp%\bat_to_bat.bat" <nul & exit /b

---

Or with all the shares in one bat calling cmd and executing commands...4

---

@echo off && >nul chcp 1252 & type nul >"%temp%\bat_to_bat.bat"

>"%temp%\bat_to_bat.bat"^
    ( 
     echo/    @echo off & color 0a
     echo/    rem :: Configurando IP: 192.168.1.100 ^| Mascara: 255.255.255.0 ^| Gateway: 192.168.1.1
     echo/    netsh interface ip set address name="Ethernet" static 192.168.1.100 255.255.255.0 192.168.1.1
     echo/    rem :: Configurando DNS Primario: 1.1.1.1
     echo/    netsh interface ip add dns "Ethernet" 1.1.1.1
     echo/    rem :: DNS Secundario: 1.0.0.1
     echo/    netsh interface ip add dns "Ethernet" 1.0.0.1 index=2
     echo/    ssh [usuário]@192.168.1.1
     echo/    [senha]
     echo/
    ) && start /max cmd.exe /k call "%temp%\bat_to_bat.bat" <nul & exit /b

• Obs.:

1. Edit/adjust the line with the ips netsh interface ip...

2. The bat needs to run as Administrator

Answer 2

only need to open cmd with the /C command, everything after the /c is copied to console.

example:

start cmd /C ping 10.0.0.1 -t